6
ASSEMBLY
1. Familiarize yourself with the jack.
3. Refer to picture 2 when performing this step.
Press Quick Disconnect on handle piece 2, this
will allow slide handle pieces 1 and 2 connect,
align the holes on both sections to allow quick
disconnect to trigger. Quick disconnect will
automatically pop out when hole position is
correct.
4. Unfasten the screw located in the Handle Socket
to insert the assembled handle.
5. Line up the square whole located at the bottom of
the handle over the square bolt inside the Handle
Socket. (SEE IMAGE STEP 6)
6. Secure the handle in place by tightening the
screw in the Handle Socket Without any vehicle
on the jack. Cycle the lift up and down several
times to insure the hydraulic system is operating
properly. (Perform to the Air Purge Procedure
before first use.)
2. Prior to assembly, carefully remove the stopper
attached to the handle socket. CAUTION: The
socket will tend to spring upward when the
stopper is removed. To prevent possible injury,
place one hand on the top of handle socket to
control the upward motion of the handle socket
, and then carefully remove the stopper. After
removed slowly allow handle socket to rise back
into resting position.
Lifting Arm
Saddle
Front Wheel
Handle
Rear Swivel
Casters
Pump Plunger
Oil Fill Plug
Stopper
Quick
Disconnect
Handle Socket
Screw
Handle
PC. 2
Handle
PC. 1
WARNING:
Do not lift or carry jack by handle.
Handle could dislodge and jack may fall,
resulting in possible injury or property damage.
Once retaining stopper is removed,
SLOWLY
allow handle socket to rise back into resting
position. Use
CAUTION
when removing retaining
clip, handle socket will spring forward rapidly.
WARNING!
