PowerHub
TM
User Manual, Version 1.2
12
5
WEB-BASED CONFIGURATION
All settings on the PowerHub can be controlled through the web-based configuration utility. To
access the utility, launch a web browser on a computer that is connected to the PowerHub and
enter the PowerHub IP address into the address field. The factory default IP address is
192.168.0.150
. If the IP address is forgotten, refer to section 8.2 for instructions on how to
reset the factory defaults.
5.1
The Status Tab
When the configuration page is loaded, the status tab will be displayed as shown below in Figure
3. The status tab displays the current state of each output, the measured input and output
voltages, the internal temperature of the unit, and the fan status. This page is configured to
automatically refresh once every two seconds.
Figure 3: The status tab of the web based configuration utility.
The output status reflects the current state of each output. The possible states are
ON
,
OFF
,
and
ERR
.
When the output is set to the
ON
state, the positive output terminal is connected to
the output voltage via a solid state relay. In the
OFF
and
ERR
states, the positive output
terminal is disconnected from the output voltage and left floating.
