TK220 GPS Car Alarm Website:www.t10.cn, email:[email protected] User Manual
Page
22
The SOS button is already fixed to the wiring harness.
Please fix the SOS button secretly under the left of the dashboard so that
the driver can easily touch it in case of emergency.
Fix the relay
The (P1 & P2) points of the relay are used to kill the engine. User can use
them to control the engine ignition loop or the power supply loop of fuel pump,
so as to stop the car.
If you fix the device on truck, please use 24VDC relay.
Connect with car central lock system.
The connections with original central lock system is similar to that of
normal car alarm. please check what kind of central lock system your car has
firstly, then do the connection according to the correct wiring diagram.
Fix the ACC ignition wire (White line)
Connect the White line to the ignition key ON position.
Fix the door switch wire (Blue line)
Connect the BLUE line with the car door switch.
Fix brake switch wire (orange line)
When the brake is pressed down, this line will be connected to GROUND.
Fix the power supply wire (Red line and black line)
The device can work with +12VDC/24VDC power supply. Please connect
the power supply lines directly to the car
’s battery.
For the truck, it is 24VDC power supply, the device can also work on truck,
but you need use 24VDC relay to stop the car.
(2) Check the wiring:
Try to use the double-sticky paper or other material to fix the device.
Fasten tightly the junction point of accessories and wires. Pay attention to
insulation and precaution of water and hot temperature. Please check the
installation according to the wiring diagram.
(3) Check the function
