User Manual VOXter
®
WL-BT 1006
5
th
February 2009
topsystem Systemhaus GmbH
Page 8
2.5.1 Status display
The lamps in the lower left corner of the front side show the power status as soon as the
devices is switched on. The light signals are as follows:
Upper LED red,
continuous light
The mute function of the VOXter
®
has been activated.
This can only be done in the picking application.
Middle LED red,
flashing
The battery charging status is below 25%. The VOXter
®
should be charged after the current picking order has
been completed.
Middle LED green,
flashing
VOXter
®
is ready for work; the battery is charged.
Lower LED green,
continuous light
The lower LED shows a continuous light as long as the
VOXter
®
is connected to the charging station and is
being charged.
Lower LED green,
flashing
The lower LED shows a flashing light when the VOXter
®
is connected to the charging station and is fully charged.
Lower LED red
continuous light
A problem has occurred while charging the battery.
Please remove the battery and place it in the charging
station again.
Lower LED rot,
flashing
The allowed temperature for charging the battery was
exceeded. The temperature for charging has to be
between 0°C/32F and 40°C/104F.
Table 1: Status display
3 Power supply of the VOXter
®
The VOXter
®
is powered by a rechargeable lithium-ion battery allowing an operating time of
about ten hours.
A spoken warning is issued automatically via headset if the power gets low during work. If
the battery charging status is below 25% the LED in the middle shows a flashing red light.
As soon as you recognize the low battery status please make sure the power supply is re-
established as soon as possible by inserting a charged battery or by placing the VOXter
®
in
the charging station.
At the end of each shift, always connect the device to the charging station in order to
recharge the battery to its full capacity! Make sure you only use fully charged devices at the
beginning of a shift.
