OUTDO O RS & INDO O RS
SPEAKER
OUTDO O RS & INDO O RS
SPEAKER
(Figure A)
ONE LOUD SPEAKER
(Figure B)
MULTIPLE QUIET SPEAKERS
Speaker coverage range: Direct the center axile of the speaker to the flat surface
of receiving area. The speakers of 90 90 series can spread the speaker tone to all
the directions at the axile of 45 . If you use the speakers in a large room, you can
divide the room to some zones. Then decide the installing location of the speakers .
45
45
45
45
45
45
45
45
VERTICAL
HORIZONTAL
Installation Description
6
Every reflection will loss the energy. When the acoustic hit the reflection surface,
the room will be filled with random reflected acoustic wave. The music and address
will be complex. It is recommended that install more speakers and make the
volume of speakers lower to reduce the reverberation in high reverberating room.
INDOOR INSTALLATION DESCRIPTION:
TAP series speakers are designed specially for fixing and using in different
circumstances. The property of speakers may be different due to different
circumstances. There is an acoustic surface (wall, floor and ceiling) in a closed
room, so the acoustic indoor will turn complex. When acoustic wave hits the
surface, a part of acoustic energy is
others are absorbed.
Reflection and absorption are depending on the frequencies of acoustic wave
and angle of hitting surface. When operate the cabinet, both man& furniture
can absorb the acoustic energy. Please note the position of man and furniture
when installing. Reverberation is the results of the reflected acoustic wave
continue bouncing between the surfaces.
reflected,
(1)
(3)
(2)
(4)
6
Installation Description
Note:
Step 1:
Step 2:
Commercial audio installation system must conform to local building
laws. When install speaker on wall or ceiling, please consult a building designer
with a license or a professional engineer. The corporation won't be responsible
for the improper installation or damage because of not conforming to installation
description.
Installation procedure of the bracket(bracket
is very simple & convenient, the appearance is pleasing to the
eye.
Fasten the bracket
on the wall with screws. The wall material must
support the weight of the cabinet.
Place the body of cabinet in bracket
and lock the screws tightly.
CS-2 is for TAP20A/20T, CS-3 for
TAP40A/40T)
Use screw
bracket
and bracket
and use steel rope
to connect two brackets.
Step 3:
(1)
(2)
(3) lock
(1)
(2)
(4)