1- Mono MIC Input
The MX series is equipped with 4 low-noise mic preamplifiers with
optional phantom power providing up to 50 dB of amplification.
You can connect almost any type of microphone. Dynamic
microphones don't need phantom power. Use phantom power
only with condenser microphones but make sure that the phantom
power switch is disengaged before connecting the microphone.
Phantom power will not damage your dynamic microphones but
it may damage tube or ribbon microphones so make sure to read
the microphone instructions manual before engaging phantom
power switch. There are also equipped with 1 / 4" TRS balanced
and TS unbalanced LINE IN plug, you can connect with line-level
instruments, such as synthesizers, key-boards, drum machines or
effect devices.
NOTE: Never try to connect a line-level signal to the XLR MIC
input when the phantom power is engaged, doing this you may
seriously damage your equipment.
2- STEREO LINE INPUTS
They are organized in stereo pair and provided with1/4" TRS jacks. It is used to connect the
stereo device, plug both the left input and the right input. Using the left input if connect a
mono input signal to the STEREO INPUT, the signal will appear on both sides.
3- GAIN CONTROL
This GAIN control is used to control the input sensitivity of the MIC and LINE inputs. The
adjustable range goes from 0 dB to 50 dB.
5- +4/-10 Switch
+4/-10 switches are used to select the input sensitivity of the line inputs on the stereo
channels. +4 dBu is suitable for professional audio devices and -10 dBv is suitable for
general devices. If not sure to use which setting, try +4 dBu first, then change it to
-10 dBv if the volume is too small to be satisfied.
4- 75 Hz Low-Cut Switch
By pressing this button you will activate a 75 Hz low frequency filter that cuts the bass
frequency below 75 Hz. You can use this switch to reduce the hum noise caused by the
mains power supply, or the stage rumble while using a microphone.
EQUALIZATION
The MX.22 / 2FX is equipped with 3-band EQ on all the channels while the MX.26 / 2FX
has 3-band EQ with sweepable MID on all mono channels and 4-band EQ on stereo
channels. All bands provide up to 15 dB boost or cut.
6- LINE/MP3 Switch
By pressing this button, it will switch to the MP3 mode, then the MP3 signal can be sent
to this channel or the Main Mix channel; by releasing this button, LINE IN inputs signal
will send to the line input channels.
FRONT PANEL
7- HIGH
This is the treble control. You can use it to get rid of high frequency of the human voice.
The gain range goes from -15 dB to +15 dB with a centre frequency of 12 kHz.
CONTROL ELEMENTS
2
5
6
LINE
MP3
LINE
MP3
1
3
4
GAIN
75Hz
3
Содержание MX.22/2FX
Страница 1: ...USER S MANUAL NF03522 1 0 ...
Страница 2: ......
