Topcon MACHINE CONTROL AG System Five, Руководство оператора

Страница: 14 / 112

Introduction and Setup
Topcon AG System Five Operator’s Manual
1-2
Overview
The System Five™ Control Box can be connected to a grade sensor,
such as a laser receiver to control elevation, as well as a slope
sensor to control the inclination or slope of an implement. The
Control Box receives signals from the sensor and determines
whether the implement is above, below, or at the desired grade. If a
grade correction is needed, the Control Box sends a signal to the
control valve, raising or lowering the implement until it is on-grade.
The operator always has full control over the system, allowing
automatic or manual control. Changes in grade can also be dialed in
from the Control Box, as well as many other operational and
performance functions.
Care and Preventive Maintenance
In general, you should follow these guidelines:
• Always clean and thoroughly dry the removable components
before storing them in carrying cases. Use a clean, soft cloth
moistened with a neutral detergent or water.
• Keep carrying cases clean and dry. Do not leave them open and
exposed to the elements.
• Some moisture on the Control Box and its components is
acceptable during working conditions. Do not spray water or
use high pressure steam cleaner hoses directly on cables and
components.
• Use protective connector caps on cables when not using the
System Five for a period of time. Water accumulating on the
connectors can cause electrical shorts.
Refer to your laser’s Operator’s Manual for care of the laser
transmitter and sensor.