Topcon HiPER GD, Руководство оператора

Страница: 38 / 180

Introduction
Topcon HiPer GD and HiPer GGD Operator’s Manual
1-16
Front Panel
Figure 1-2 and Figure 1-3 on page 1-17 show front panel
components for the HiPer GD and HiPer GGD.
Figure 1-2. HiPer GD Front Panel
• MINTER – The Minimum INTERface for the HiPer
GD and HiPer GGD receivers. The MINTER consists
of two keys and four, three-color LEDs. See “Using the
MINTER” on page 4-2 for descriptions and usages of
the MINTER components.
• Reset – This key performs a hard reset for both the
receiver board and the power board. Once this key is
pressed, the controllers governing the receiver and
power boards reboot and the device restarts.
This key can be used to leave Zero Power Mode or if
the receiver does not respond to commands. See “Using
the MINTER” on page 4-2 for more information on the
Reset key.
• Four serial ports:
–Port A used for communication between the receiver
and a controller or any other external device.
–Port B used for an optional third serial port.