Topcon HiPER GD, Руководство оператора

Страница: 101 / 180

Surveying with the Receiver
1-866-4TOPCON www.topconpositioning.com
3-19
10. Select the Positioning tab and set the Position Masks,
Elevation mask parameter to 15 (Figure 3-13).
Figure 3-13. Receiver Configuration – Positioning
11. Select the Base tab and set the following parameters
(Figure 3-14 on page 3-20):
• GPS/GLO at one time – enable
• Antenna position – enter Lat, Lon, and Alt values. Do
one of the following:
–If known, type in the values.
–Click Get from receiver.
–Enable Averaged and enter the Averaged Span in
seconds, then click Apply. Click Tools->Reset
receiver and wait until the specified interval (span)
completes. Examine the Base coordinates on the Base
tab, they should correspond to the coordinates obtained
from the average. Click Refresh if the coordinates are
zeros.
NOTICE
The reference geodetic coordinates you specify
on this tab relate to the antenna L1 phase center.