5
KIT NUM-2
EN
INSTALLATION
WARNING
ELECTRIC SHOCKS CAN BE FATAL
Only experienced personnel authorised by the manufacturer may carry out the installation. During installation, make sure
that the generator is disconnected from the mains.
Video for the kit’s installation:
NEOPULSE 400 G / 500 G PULSEMIG 400 G / 500 G
NUM-2
1
2
The reels are delivered in «Master» configuration
(N°1).
For use in double wire feeders, one of the two wire
feeders must be configured as a «Slave» wire feeder
(N°2). To configure it, follow the instructions in the
video.
https://www.youtube.com/playlist?list=PL7Y7wApgIJaSwDJ9f
3_4KyWe84UZrinBp
The installation video of the kit is also available on the USB key supplied with the generator.
Any access to internal areas beyond the areas described in this video guide is prohibited and voids the warranty and any other form of support.
Indeed, these manipulations may be damaging to the parts and/or the internal electronic components of the generator.
HARDWARE ERROR
If the following error appears on the display, the configuration order
of the wire feeders «Master» N°1 / «Slave» N°2 was not followed.
The configuration is visible in the video (see above).
Master
Slave
HARDWARE Error
NODE : MMI 2
CODE : 0000
BAD BANK ID for MMI-5
SCREEN DISPLAY
The functionalities of the «Slave» wire feeder are
limited.
Wire Feeder N°1 = Master
Wire Feeder N°2 = Slave
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.
