TOP VEHICLE TECH KWBMW9, Руководство по установке

Страница: 3 / 8

3
www.topvehicletech.com
FITTING GUIDE
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet MUST be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heating elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be dropped down to route the antennas wiring. To do this you will need to
remove the clip holding the hydraulic arm in place. Then all that is needed is to let the glovebox fall open.
1. Using a bojo tool on either side, remove the cilmate control panel and disconnect any/all wiring from
behind.
2. With the climate control panel removed, this will reveal 2x screws that will need to be undone to free
the main radio. Once free, pull out of the dashboard and disconnect all the wiring.
FASCIA PLATE SET-UP
1. Take the OEM air con panel and begin to unclip the automatic air con unit, this can go directly into the
new fascia.
3. With the radio removed, you will then need to remove the 4x screws and 2x bolts that hold the plastic
cage into place. Once these screws and bolts are undone, remove the cage completely.
3. When happy with the alignment, and the “ Stereo Installation ” process is complete, screw the stereo
into the dashboard using the pre-existing screws. Then simply install the fascia on top.
2. Attach the brackets to the new stereo using the screws within the kit. With the brackets attached, offer
the whole unit to the back of the fascia and test fit within the vehicle to gauge the correct depth.