4
www.topvehicletech.com
1. Take the Infodapter interface in hand and connect both the 12-way stereo patch lead and the 14-way
steering wheel harness connectors to the corresponding ports.
2. Connect the bullet connector from the stereo patch lead to the ‘steering wheel remote input’ on the
back of the new stereo.
5. Attach the antenna adapter to the vehicles pre-existing connection and the back of new stereo.
FITTING GUIDE
6. Connect the DAB antenna’s SMB connector to the back of the new stereo.
7. Attach the additional wiring on the harness to the back of the stereo:
Pink
- Speed Pulse
Green
- Park Brake
Purple
- Reverse
Grey
- Mute
8. When all the above wires (and any additional accessories) have been connected, finally make the
connections between the stereos ISO connection and vehicles pre-existing connector.
STEREO INSTALLATION
4. Attach the yellow male RCA connector to the reverse camera input of the stereo.
To add an aftermarket reverse camera
: attach the yellow female RCA from on the camera extension
harness to the male yellow RCA of the aftermarket reverse camera.
BEFORE INSTALLATION - DIPSWITCHES
On this particular interface are a set of dipswitches. These dipswitches have the following properties:
1: OFF - Kenwood.
ON - Pioneer.
2: OFF - NTSC reversing camera (default). ON - PAL reversing camera.
3: Change from OFF to ON to ‘reset’ screen setting to factory default.
Note: during this procedure, the screen background will change to red and no settings adjustments can be made.
4: Not Used.
3. Attach the 4-pin camera extension harness to the relevant port on the Infodapter interface.
