TOP VEHICLE TECH GRKVW01, Руководство по установке

Страница: 3 / 8

3
www.topvehicletech.com
FITTING GUIDE
STEREO REMOVAL
FASCIA PLATE SET-UP
1a. Use a panel removal tool to release the air cone unit and remove 2x screws located here (this step is
only required for Volkswagen Golf vehicles).
1b. Use a panel removal tool to remove the trim surrounding the main radio. This will reveal 4x screws
which will need to be removed.
2. Once free, pull the head unit out of the dashboard and disconnect all of the wiring in the process.
1. Attach the brackets to the new stereo. These brackets allow you to set the specific depth of the unit in
relation to the fascia plate. Start by lining up the spacers (Fig 1.) on the inside of the plates
(Fig 2.) .
Fig 1. Fig 2. Fig 3.
2. Attach the spacer and plate combination to the corresponding side of the stereo using the screws that
come with the stereo. Test this set up outside of the dashboard by sliding into the radio cage.
3. Take the fascia in hand, and place it atop the caged radio combination. If the depth/alignment of the
stereo hangs out too much/is reccessed to far, use the radio removal keys (Fig 3.) to release the stereo
from the cage and repeat the process.
4. When you’re happy with the bracket alignment, you can proceed to install the fascia into the dashboard,
utilising the pre-existing screws.