3
www.topvehicletech.com
FITTING GUIDE
STEREO REMOVAL
FASCIA PLATE SET-UP
1. Use a panel removal tool to unclip the side panel located vertically by the passenger side door.
2. With the brackets now attached to the fascia plate, proceed to feed the new stereo in between the
brackets. Adjust in accordance to the front of the fascia panel and screw into place with flat ended bolts
(not provided).
3. Once the “
Stereo Installation
” process is complete, push the stereo into the dashboard, and complete
the installation by placing the original fascia trim over top and reassembling the dashboard in reverse
order.
2. With the panel out of the way, there should be 1x torx screw holding the main fascia panel, undo this
and once free, proceed to unclip the long main fascia panel.
1. Using the 6x phillips screws within the kit, attach the brackets to the appropriate sides of the new fascia
plate.
3. With the main radio exposed, use a set of radio release keys (or a pick tool) and undo the 4x spring clips
holding the main head unit into place. Once free, remove it completely whilst disconnecting all of the
wiring.
7. Attach the antenna adapter to the vehicles pre-existing connection and the back of new stereo.
2. Take the steering wheel control interface and attach the 14-way steering wheel harness connector to
the relevant side.
STEREO INSTALLATION
3. Make a cut within the orange and purple loops on the back of the patch lead connector. Then proceed
to attach ‘
Key 1
’ to the light blue ‘SWC Remote’ wire on the stereo. When done, connect the 12-way
connector to the steering wheel control interface.
4. Attach the 4-way camera extension harness to the steering wheel control interface.
5. Connect the male yellow RCA to the ‘reverse camera input’ on the back of the new stereo.
1. Take the interface and set the dipswitches accordingly
(note that these are default to off)
:
ON (DOWN)
OFF (UP)
DIPSWITCH 1
Pioneer head units
All other head units
(Default)
DIPSWITCH 2
Reverse Camera PAL
Reverse Camera NTSC
(Default)
DIPSWITCH 3
Reset factory settings (switch) Reset factory settings
(Default)
DIPSWITCH 4
Not Used
Not Used
6. Connect the aftermarket reverse camera (if required) to the female yellow RCA on the camera extension
harness.
Note: ensure the ‘Camera Connected’ option in the ‘Preferences’ menu is set to ‘Yes’ for the camera to
function correctly.
8. Attach the additional wiring on the harness to the back of the stereo (where applicable):
Pink
- Speed Pulse
Green
- Park Brake
Purple
- Reverse
Grey
- Mute
