3
www.topvehicletech.com
FITTING GUIDE
1. Using a set of radio release keys, insert them into the front of the single DIN radio. Once clicked into
place, pull the radio out and disconnect all of the wiring.
STEREO REMOVAL
FASCIA PLATE SET-UP
DASH MODIFICATION
Some plastics will need to be cut and removed from the dashboard to make space for the new car stereo.
Measure where the stereo will sit and take due care when modifying the vehicle. TopVehicleTech always promote the
help of professional installers. TopVehicleTech will not be held responsible for any damage to the vehicle.
6. Attach the aftermarket radio to the brackets using the screws within the kit. Align this combination then
to the rear fascia aperture and when lined up correctly, fix into place using the screws from the kit.
5. Undo the 4x screws that surround the main radio. When done, pull the radio out of the dashboard and
disconnect all the wiring.
5. Take the pre-existing metal clips from the original fascia and transplant them to the corresponding
prongs of the new fascia plate.
2. Remove the 2x screws located either side of the climate controls on the main fascia panel. Once done,
firmly pull the fascia panel at top, middle and bottom locations to pull away and disconnect all of the
wiring from behind the fascia.
3. Undo 2x screws located on either side of the main dashboard that hold the centre console in place.
Once undone, use a bojo tool to lift the centre console panel and remove whilst disconnecting any wiring.
4. Undo 2x screws that surround the bottom air control panel as well as the 2x screws either side of the
top hazard switch panel. When all these screws are undone, simply pull these panels forward, this is to
give you enough room to remove the main radio.
1. Begin by relocating the clock by undoing the 4x screws surrounding it. When loose, relocate into the
aperture on the new fascia panel.
2. Follow on to transfer all the appropriate buttons and cigarette lighter port into the new fascia panel.
3. Any additional buttons, as well as the hazard warning switch, will need to be located into the new side
panel. Once the “
Dash Modification
” is complete, this can then be housed in the side of the dashboard.
Use the trim panel behind the dashboard to secure into place.
4. Attach the climate control display decal into location on the rear of the fascia.
7. When all the components are assembled within the new fascia, begin to reconnect all the wiring to the
fascia. When the stereo has been connected, simply clip the whole assembly to the dashboard and use the
2x pre-existing screws to complete the installation.
