Top Tools 42E500, Инструкция по эксплуатации

Страница: 7 / 52

- 7 -
It ensures that hot gun nozzle or other hot parts have no contact
with any surface in workshop or a table.
10. When the work is finished, disconnect the glue gun from power
supply and allow it to cool down before storing. After glue gun is
cooled, store it in dry place away from sunlight.
11. Do not overheat the glue gun, protect against oil and sharp
edges etc.
12. Always use common sense. Do not operate the glue gun when
you are tired or under influence of alcohol or medicines.
13. Glue gun is designed for use with glue sticks with diameter 11
mm.
14. Do not use melted glue on surfaces coated with oil paint or wood
stain unless you can clean the spot you plan to glue.
15. Do not use glues other than designed for use with glue guns.
16. Do not substitute structural joining elements with glue applied
with the glue gun!
17. To avoid hazards, if power cord is damaged it should be replaced
by the manufacturer, specialized repair workshop or by qualified
person.
TECHNICAL PARAMETERS
PARAMETER VALUE
Supply voltage 230 V AC
Charging frequency 50 Hz
Rated power (max)* 16W (40W)*
Glue stick diameter 11,2 mm
Temperature of heating element 160-180°C
Heat up time 5-6 min.
Efficiency ok.5 g/min
Protection class II
Weight 0,2kg
USE
1. Joined surfaces should be as flat and smooth as possible. Before
starting to glue clean surfaces with solvent. Surfaces must be dry
with no trace of oil.
2. Insert glue stick into the gun and wait 5 to 6 minutes until it is hot.
3. Glue dries within 60 seconds. Single operation of applying the
should not exceed 40 seconds.
4. To finish operation, press two glued surfaces against each other
evenly for approximately 5 minutes.