Priming Information
When using your RecoveryWrap System it is important to
PRIME
This can be done by operating the RecoveryWrap System
with the new pad attached for at least 3 min set to
1. Press the Power Switch to the ON “ ” position.
2. Prime the unit: Adjust the Temperature Control Knob to a
comfortable setting.
to continue.
RecoveryWrap System
Instructions for Use
Please read these instructions completely and
carefully before applying this product. Correct
application is important for proper function.
Control Unit
Pad
Tubing Set
Setting up the system is a simple three-step process. (1) The user
with ice and water, (2) then applies the RecoveryWrap Pad with
an insulation barrier between the pad and skin, around the
attaches the control unit to the pad via the tubing set.
Warning
NNO part of the pad should directly touch the skin.
Once the control unit is turned on, cold water is passed through
then circulated through the pad, drawing heat from the body
through the tubing set to the control unit where it is re-cooled
and then re-circulated back to the pad.
When using this system, please check the skin where the
pad is applied periodically. Discontinue use if continued
numbness, skin discoloration, blisters, etc. are present. Please
refer to your health care professional prior to applying this
system and/or using the system for extended periods of time.
Warning
NO part of the pad should directly touch the skin.
Patient Discharge Instructions
1. Assess Patient: Screen the patient for any contraindications
and/or associated risk factors. If the patient has any contrain-
dications, do NOT dispense the RecoveryWrap System for treat-
ment. Consult a healthcare practitioner regarding the use of the
RecoveryWrap System.
2. Quick Guide: Refer to the quick guide for setup and directions
to apply the pad correctly. Instruct the patient on how to
properly use the RecoveryWrap System.
3. Protocol: Instruct the patient on the prescribed healthcare practi
tioner protocol (frequency and duration of use). Instruct patient
on periodic assesment of the skin area and the treatment period.
4. Potential for Injury: Instruct patient that improper use can
result in serious inury. Emphasize proper use, pad placement,
skin inspection, and following the prescribed protocol.
5. Pad Application: DO NOT apply the RecoveryWrap Pad direct-
ly to the skin. There should be a wound dressing or insulating
material between the skin and the pad.
NO part of the pad
should directly touch the skin.
6. Skin Inspection: Instruct the patient to visually inspect the skin
per the healthcare practitioners instructions, typically every 1
to 2 hours.
7. Discontinue use of the RecoveryWrap System if you experience
any adverse reactions such as: burning, increased pain, increas-
ed swelling, increased redness, discoloration, itching, welts, blis-
ters or any other changes to the skin appearance or condition.
Contact your healthcare practitioner immediately.
Indications and Contraindications
General Indications for Cold Therapy
There are general indications for using cold therapy across the
body and in various situations:
• First aid after trauma
• Relief of pain
• Prevention or reduction of swelling of traumatic origin
Cold is preferred during treatment of acute injury, sub-acute
Contraindications for Cold Therapy
Users should be aware of situations where cold therapy may
-
wise contraindicated for use.
• Cold Uticaria
• Cryoglobulinemia
• Raynaud’s Syndrome
• Proximal cold hemoglobinuria
• Vasospastic disease
• Cold hypersensitivity
• Peripheral neuropathy (as in some cases in diabetes)
• Compromised local circulation
Users should take caution in applying cold therapy over open
sores and abrasions. At a minimum these areas should be cleaned
and bandaged.
Directions For Use:
1. Unlock and remove lid by rotating handle away from the
vertical position.
1
2
3
O FF
O N
O FF
O N
switch
O FF
O N
40˚F
70˚F
5. Replace lid onto the unit- make sure to line up the cutout
with the notch on the lid.
6. Lock lid onto the unit by returning the handle to the
vertical position.
7. Connect BLUE connector hose to the unit by aligning the
white dots and pressing into the slot.
8. Connect BLUE connector hose (opposite end) to the cold
therapy pad by aligning the white dots and pressing together.
9. Attach the power cord to the unit.
10. Turn unit on with the green button on the top of the lid.
11. Adjust temp control knob to the image showing 3
12. Allow unit to PRIME for 3 minutes- additional ICE/WATER
may need to be added after this process – Turn unit OFF
before removing the lid to add ICE/WATER to the unit.
13. Over a dressing or moisture barrier apply the pad to the
directly to the skin.
14. Adjust the temp knob based on physician recommendation.
pad.
Patient Use Tips
1. Use cubed ice for best performance.
2. You may disconnect the RecoveryWrap pad from the unit
blue tabs on the hose coupling and gently pulling the hose
from the connector. The pad will seal itself and will not leak.
3. Do NOT run the unit without water in the container. The
pump is designed to run WITH water. Unplug the unit
before removing the lid from the water container.