3
ALWAYS CHECK THE SPEED RATING OF ACCESSORIES
. This tool will spin
accessories at 3,000 rpm. Accessories not rated for speeds this high will very likely
fly apart and could cause serious injur
y.
IMPORTANT SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS FOR 1/2 INCH HAMMER DRILL
SPECIFICATIONS
15. USE EYE PROTECTION.
Use a full-face mask if the work you’re doing
produces metal filings, dust or wood chips.
Goggles are acceptable in other
situations.
W
ear a clean dust mask if the work involves creating a lot of fine
or coarse dust.
16. SECURE WORK.
Use clamps or a vise to hold the work, this frees both
hands to operate the tool.
17. DON’T OVERREACH.
Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
18. MAINTAIN TOOLS.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories.
For safe performance. Keep handles dry, clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING.
Be sure the switch is in the
OFF
posi
-
tion before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES
before turning the tool on. Left attached, these parts can fly
of
f a moving part and result in injur
y.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF.
Have your tool repaired before using it.
22. DISCONNECT THE PLUG FROM THE POWER SOURCE BEFORE MAKING
ANY ADJUSTMENTS.
Changing attachments or accessories can be dangerous
if the tool could accidentally start.
23. STAY ALERT.
W
atch what you are doing & use common sense. Don’t operate
any tool when you are tired.
24. CHECK FOR DAMAGED PARTS.
Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate prop-
erly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mountings, and other conditions
that may affect its operation. Inspect screws and tighten any ones that are
loose.
Any part that is damaged should be properly repaired or replaced by
an authorized service center unless otherwise indicated elsewhere in the in-
struction manual. Have defective switches replaced by an authorized service
center
. Don’t use the tool if switch does not turn it on and o
ff properly.
25. REPLACEMENT PARTS.
When servicing, use only identical replacement
parts.
26. SERVICE AND REPAIRS
should be made by qualified repair technicians at
an authorized repair center. Improperly repaired tools could cause serious
shock or injury.
14. DRESS PROPERLY.
Don’t wear loose clothing or jewelry; they can be
caught in moving parts. Protective, non-electrically conductive gloves, protective
eyewear and non-skid footwear are recommended. Wear protective hair
covering to contain long hair and keep yourself from harm.
Voltage: 120 volts
AC, 60Hz.
Current rating: 6.7 Amp
No load speed: 0-3,000 RPM
No load impacts: 0-48,000 BPM
1/2” keyless chuck