NAEP0011-R00 Rev 171012
Page 1 of 2
TOOLSAND
, a brand of Trepmall, LLC, 11625 Custer Rd, Suite 110362, Frisco, TX 75035
1-888-600-8808, [email protected], toolsand.com/support
Your Toolsand LED worklight has a stepless dimming feature that allows you to choose your desired bright-
ness level from low to high and anywhere in between.
1. Press and hold the red power button to enter the stepless dimming mode.
2. The brightness of the worklight will change, either brighter or dimmer, depending on where you started.
When the worklight has obtained the brightest, or the dimmest level, it will blink off-on-off-on. If you continue
to hold the red power button, the brightness will continue to change after completing the off-on-off-on cycle.
3. When the worklight is at your desired brightness level, release the red power button.
Dimming Your Worklight
Turn your worklight on and off by using the red power button.
1. Press (and release) the red power button once for the medium brightness setting.
2. Press the red power button again for the high brightness setting.
3. Press the red power button one more time to turn your worklight off.
Turn On Your Worklight
For safety purposes the battery in your worklight is only partially charged. Before first use you should fully
charge the battery pack.
1. If your worklight is on, turn it off by pressing (and releasing) the red power button.
2. Choose the AC or DC charging adapter and connect it to the appropriate power source.
3. Uncover the charging jack on your worklight by opening the rubber “DC” cover.
4. Connect the charging adapter to the charging jack and observe the four indicators lamps. Some lamps may
be fully lit (solid) while one should be blinking. A blinking lamp indicates that the battery is charging.
5. The battery should be fully charged in about 2-3 hours, indicated by four fully-lit indicator lamps. Remove
the charging adapter and close the rubber “DC” cover on your worklight.
Charging and First Use
Carefully read and follow
all charging and handling
instructions.
Contains
Lithium - Ion Battery
WARNING
-Use only the included AC or DC charging adapters with your Tool-
sand worklight. The use of an incorrect adapter may create a risk
of fire. If you need a replacement adapter, use only a Toolsand AC
or DC adapter.
-Use only a battery or battery pack specifically designed for your
Toolsand worklight. Use of other batteries or battery packs may
create a risk of injury or fire.
-If your worklight includes a removable battery pack, when the
battery pack is not attached to the worklight, keep it away from other metal objects like paper clips, coins,
tools, keys, nails or objects that can create a short-circuit across the battery terminals.
-Do not store the worklight or battery in locations where the temperature may exceed 50
ﾟ
C (122
ﾟ
F).
-Do not disassemble, crush, or incinerate the worklight, battery pack, or battery cells.
-Do not use or charge a damaged battery pack.
-Do not leave the charge adapter connected to the worklight for more than 24 hours.
WARNING !
PLEASE CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS BELOW
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Thank you for purchasing a Toolsand rechargeable high-power LED worklight. Our
worklights include ultra-efficient COB LEDs for cool operation and long battery life.
Rainproof IP44 and IP65 ratings allow you to use your light both indoors and out, in
any weather conditions. The rechargeable high-capacity lithium-ion battery provides
hours of bright light.
NAE0002-A1
NAE0001-AH1
LED WORKLIGHT INSTRUCTION MANUAL
For Item Numbers:
NAE0001-AH1 and NAE0002-A1
TM
