Customer Helpline
1300 889 028
12
Operating Instructions
OPERATION
1. ON / OFF SWITCH (SEE FIG. D)
Depress the On/Off switch to start and release it to stop your drill.
The on/off switch is fitted with a brake function which stops your chuck immediately when
you quickly release the switch.
It is also a variable speed switch that delivers higher speed and torque with increased
trigger pressure. Speed is controlled by the amount of On/Off switch depression.
WARNING: Do not operate for long periods at low speed because excess heat
will be produced internally. When overload occurs, release the On/Off switch
immediately to avoid the motor overheating.
2. SWITCH LOCK (SEE FIG. E)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility of
accidental starting when not in use. To lock the switch trigger, place the rotation control
in the center position.
3. REVERSIBLE (SEE FIG. F1, F2)
Forward rotating: push the forward/reverse rotation control to the left (the drill points
away from you). It is used for drilling and screw driving.
Reverse rotation: push the forward/reverse rotation control to the right (the drill points
away from you). It is used for remove screws or release a jammed drill bit.
WARNING:
Never change the direction of rotation when the chuck is rotating, wait
until it has stopped!
4. TWO-SPEED GEAR CONTROL (SEE FIG. G)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is 1) or
HI (mark is 2) speeds. A slide switch is located on top of the drill to select either LO or HI
speed. When using the drill in the LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the drill in the HI speed range, the speed
will increase and the drill will have less power and torque.
Gear I
Low speed range: for screwdriving or working Large diameter drill.
1
1
2
2
CLOSE
OPEN
D
E
F1
F2
G
H
I
J
C
B