- 4 -
2
）
When install the upper and down limit, do not confuse the wire number.
3
）
Fix the film panel first and then test the button, or else the bulb and cable lines may
be damaged.
V. Installation and operating
1.
Move the machine to its final location, make sure it is free of any damage
and ready of all the parts and accessories.
2.
Connect the machine to the mains. Check the mains values before
connecting.
3.
Install the film mandrel and left and right cabinet of print roll (fasten the
screws). Make sure the ends are symmetrical. Press the start button and the
rollers are rotating. Make sure the machine run normally. Then try
lamination and check the effect and quality of lamination.
4.
Film mandrel and liner paper roller can be installed or removed quickly.
three rubber strips which can be rolled are mounted on the aluminum
mandrel to lock the core of the film roll. A Bakelite knob on one end of the
liner paper roller can regulate friction to ensure the same speech of main
rollers and liner paper roller to ensure the laminating quality. Turn the knob
clockwise, damping increases. While turn the knob counterclockwise, the
damping decreases.
5.
The knob on the right cabinet is for lift or drop the roller. Turn it clockwise
and the roller is lifted. Turn it counterclockwise and the roller is dropped.
When turn it counterclockwise and the top roller reaches the bottom roller,
the turning force is significantly reduced. This phenomenon is called
idle
stroke
. When the weight of the top roller is well-distributed on the bottom
roller, the laminating can be started. If you continue to turn the knob
counterclockwise, the pressure can be increased.
Adjust the parallelism and pressure of the main rollers:
：
