TC76206
User Guide
v 2 - 21/11/2014
p. 4 / 20
-
If the device was damaged in transit, do not install
or use it and contact your dealer.
-
Do not dispose of the packing. The packing can be
used to protect the device when not used for a long
time or for shipping purposes.
-
Remove all package material and check the
appliance for damages. Always clean up the
package material. It could be life threatening for
children and animals.
-
Install the appliance on a secure and firm surface.
Do not expose it to vibrations and heavy wind.
Make sure the surface can carry the device.
Mounting
Never plug in the device while mounting it.
Only use mounting material that is suitable for the
mounting surface. Please contact a technician if in
doubt.
You must strictly follow the minimum safety clearances
when mounting the appliance:
-
Distance to wall : minimum 150 cm
-
Distance to ceiling : minimum 50-100 cm
-
Distance to floor : minimum 250 cm
1.
Find a stable and dry location to mount the device.
2.
Respect the safety clearances (see Safety
Instructions) when mounting the device.
3.
Slide the lower bar in the stand and attach it.
4.
Slide the middle bar onto the lower bar and attach
them.
5.
Slide the upper bar onto the middle bar and attach
them.
6.
Slide the heating element on the upper bar and
secure it using the knob.
7.
You can set up the heater in an angle between 0°
and 45°. Attention: do not change the angle while
the device is in use. First disconnect the device, let
it cool down for 15 minutes and then change the
angle.
Replacing the lamp
Refer to the illustrations on page 2 of this manual.
1.
Disconnect the device from the mains prior to
maintenance activities. Let the device cool down
2.
Remove the screws from the side where the power
cable is not connected (Fig.A).
3.
Remove the side, the front panel and grill (Fig.B)
4.
Disconnect the lamp on both sides (Fig.C)
5.
Slide the lamp outwards (Fig.D)
6.
Insert a new lamp in the appliance.
You must mount all parts correctly before using the
appliance.
Do not handle the lamp with bare hands.
Remove finger marks with a soft cloth.
Finger marks will burn into the quartz
lamp which will cause lamp failure.
Cleaning and Maintenance
-
Disconnect the device from the mains prior to
maintenance activities. Let the device cool down.
-
Use a moist rag or a dust rag for cleaning.
-
Never use water to clean the device.
Technical Specifications
power cord
1.9 m - H05RN-F3 x 1.0 mm²
power
consumption
1500 W
power supply
230 V
50 Hz
IP rating
IP.65
radiation range
3 m
Use this device with original accessories only. Velleman
nv cannot be held responsible in the event of damage or
injury resulting from (incorrect) use of this device.
Disposal
To all residents of the European Union - Important
environmental information about this product
This symbol on the device or the package indicates
that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit
(or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This
device should be returned to your distributor or to a
local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
For more info concerning this product and the latest version of
this manual, please visit our website www.toolland.eu.
