Operating Elements
1
9
8
7
6
5
4
2
3
1 Battery cutoff switch
ON
/
OFF
2 Secondary lens
3 Primary lens
4 LED light
5 Gooseneck
6 5 V/DC 1 A Micro USB port
7 LED charging status indicator
8
Power ON/OFF, brightness
9 Removable base
The battery cutoff switch
(1)
is used to protect the battery during extended periods without use
such as during shipment or storage. Turn the battery cutoff switch
(1)
ON
after unpacking the
product.
The removable base
(9)
may leave marks or scratch delicate surfaces.
Charge the Battery
• Connect one end of the included charging cable to the 5 V/DC 1 A Micro USB port
(6)
, and the other end
to a suitable power supply.
• The LED charging status indicator
(7)
will turn off when the battery is fully charged.
Operation
• Touch the power button
(8)
to turn the power ON.
• Touch and hold the power button
(8)
to increase/decrease the brightness.
• Touch the power button
(8)
to turn the power OFF.
Remove Base
• To use the desk clamp, release it from the base
(9)
by carefully spreading both tabs from underneath
as shown.
•
Reattach the desk clamp to the base by first sliding the rear into the base
(9)
, then pressing the front
down until it “clicks” into place.
Care and Cleaning
• Always disconnect the product from the power supply before cleaning it.
• Remove loose particles using a dust blower.
• Use a lens cleaning cloth for cleaning the lens. Alternatively, use a dry, clean, soft and lint free cloth or a
dust brush. If necessary, you can moisten the cloth with a small amount of lukewarm water.
• Avoid excessive cleaning and applying too much pressure to the housing and lens.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage
the housing or stop the product from functioning properly.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines. You thus fulfill your statutory obligations and contribute to the protection of the
environment.
Technical Data
Input voltage / current ........................... 5 V/DC, 1 A via micro USB
Rechargeable battery ........................... LiPo 3.7 V, 400 mAh
LED life ................................................. 25000 h
LED brightness ..................................... 60 lm
LED runtime .......................................... approx. 3 - 5 h
LED colour temperature ....................... 6000 - 6400 K (cool white)
Clamping range .................................... max. 45 mm
Lens ...................................................... Primary: 1.75x, ø110 mm,
Secondary: 3x, ø20 mm
Charging cable ..................................... USB type A to micro USB
Operating conditions ............................. +10 to +40 ºC, 0 – 85 % RH (non-condensing)
Storage conditions ................................ +10 to +50 ºC, 0 – 85 % RH (non-condensing)
Dimensions (L x W x H) ........................ 135 x 180 x 250 mm
Weight .................................................. 300 g
Operating Instructions
LED Magnifier Light with Table Clamp
Item No. 2126184
Intended Use
The product is a dimmable LED magnifier light with table clamp. It has a removable table stand, integrated
rechargeable battery, and a touch controlled on/off/dimmer button.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
result in short circuits, fires or other hazards. Read the instructions carefully and store them in a safe place.
Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery Content
• Light
• USB charging cable
• Operating instructions
Up-to-Date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code shown.
Follow the instructions on the website.
Explanation of Symbols
The symbol with the exclamation mark in the triangle is used to indicate important information in
these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do not
follow the safety instructions and
information on proper handling in
this manual, we assume no liability
for any resulting personal injury or
damage to property. Such cases will
invalidate the warranty/guarantee.
a) General Information
• The device is not a toy. Keep it out of the reach
of children and pets.
• Do not leave packaging material lying around
carelessly. This may become dangerous playing
material for children.
• Protect the appliance from extreme
temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, steam and
solvents.
• Do not place the product under any mechanical
stress.
• If it is no longer possible to operate the product
safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer
be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor
ambient conditions or
- has been subjected to any serious transport-
related stresses.
• Please handle the product carefully. Jolts,
impacts or a fall even from a low height can
damage the product.
• Consult an expert when in doubt about the
operation, safety or connection of the appliance.
•
Maintenance, modifications and repairs must
only be completed by a technician or an
authorised repair centre.
• If you have questions which remain unanswered
by these operating instructions, contact our
technical support service or other technical
personnel.
b)
Persons and Product
• Never look at bright light sources (e.g. LED
lamps or lasers) through the magnifying glass.
This may result in eye injuries.
• Always keep the glass lenses away from direct
sunlight when the lamp is not in use. Strong
sunlight that shines through the magnifying glass
can result in the burning glass effect and may
cause a fire.
• Do not attach any objects (e.g. decorations) to
the product.
• Never mount the product in the vicinity of easily
flammable materials (i.e. curtains, fabrics, etc.).
Otherwise there is a risk of fire!
c) LED light
• Attention, LED light:
-
Do not look directly into the LED light!
- Do not look into the beam directly or with
optical instruments!
d) LiPo Battery
• The rechargeable battery is permanently built
into the product and cannot be replaced.
• Never damage the rechargeable battery.
Damaging the casing of the rechargeable
battery might cause an explosion or a fire! Unlike
conventional batteries/rechargeable batteries
(e.g. AA or AAA type), the casing of the LiPo
rechargeable battery does not consist of a thin
sheet but rather a sensitive plastic film only.
• Never short-circuit the contacts of the
rechargeable battery. Do not throw the battery
or the product into fire. There is a danger of fire
and explosion!
• Charge the rechargeable battery regularly, even
if you are not using the product. Due to the
rechargeable battery technology being used,
you do not need to discharge the rechargeable
battery first.
• Never charge the rechargeable battery of the
product unattended.
• When charging, place the product on a surface
that is not heat-sensitive. It is normal that a
certain amount of heat is generated during
charging.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2019 by Conrad Electronic SE.
*2126184_v3_1019_02_dh_m_en
