Operation
Do not look directly into the sun or a bright light source when wearing the magnifying lens. Doing so can result
in permanent eye damage.
a)
Insert/Replace Batteries
•
Locate the battery compartment
(6)
on the underside of the LED housing.
•
Use the included plus head screwdriver to remove each screw.
After removing each screw, place it somewhere where it will not
get lost.
•
Insert 3 x 1.5 V LR 1130 batteries, matching polarities as shown in the
compartment.
•
Cover the battery compartment
(6)
then gently replace the screws.
b) Lenses
Lens magnification and corresponding focal distances are: 1.5x (333 mm), 2.5 x (200 mm), 3.5 x (144 mm). The focal range
decreases as the lens magnification increases.
•
When attaching and removing each lens, hold with a soft lint free cloth to avoid fingerprints and prevent
scratching.
•
Make sure each lens is securely fastened to the lens brackets before letting go.
•
Correct focal range depends on individual eyesight and whether eyeglasses are being worn.
• Select the desired lens
(4)
then gently push into the lens bracket until it locks into place.
The curved side of the lens should be facing away from your eyes
when wearing.
•
To remove the lens
(4)
, carefully pull away from the middle.
c) Adjust Nose Bridge Pads
Do not use force to over adjust the metal nose bridge or adjust too frequently, this may cause it to break.
•
Gently adjust the metal nose bridge
(5)
in small increments, then test for fit.
•
The frame should sit comfortably on your nose, at the right height, without sliding off.
d) LED Light
Do not use force to adjust the lighting angle, this may cause damage.
•
Use the LED ON/OFF switch
(1)
to activate/deactivate the LED light
(2)
.
Care and Cleaning
•
Turn LED light OFF before cleaning. Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions
as they can cause damage to the housing and malfunctioning.
•
Use a lens cleaning cloth for cleaning the lens. Alternatively, use a dry, clean, soft and lint-free cloth or a dust brush. If
necessary, you can moisten the cloth with a little lukewarm water.
•
When cleaning the lens with a cleaning agent, make sure not to directly apply the cleaner on the lens. Always apply the
cleaning agent directly to the cloth first.
•
When cleaning, do not apply too much force on the lens or housing in order to avoid damage.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste. At the end of its
service life, dispose of the product in accordance with applicable regulatory guidelines.
Remove any inserted batteries and dispose of them separately from the product.
b) Batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries. Disposing of them in the
household waste is prohibited.
Contaminated batteries are labeled with this symbol to indicate that disposal in the domestic waste is forbidden.
The designations for the heavy metals involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead batteries, e.g.
below the trash icon on the left).
Used batteries can be returned to collection points in your municipality, our stores or wherever batteries are sold.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
Technical Data
Power supply
...................................................
3 x 1.5 V LR 1130
Battery life
........................................................
Approx. 4-5 hours
Illuminant
.........................................................
1 x LED
Color temperature
............................................
6400 K (cool white)
Lens material ...................................................
Acrylic
Magnification/focal length
................................
1.5x—333mm/2.5x—200mm/3.5x—144mm
Operating conditions
........................................
-10 to +40 °C, 10 – 90 % relative humidity
Storage conditions ...........................................
-20 to +50 °C, 10 – 60 % relative humidity
Dimensions (L x W x H)
...................................
200 x 150 x 50
mm
Weight .............................................................
25 g (without lenses)
Operating Instructions
Magnifier Glasses with LED Light
Item No. 1712604
Intended Use
This product is suitable for a range of uses e.g. craftsmen, hobbyists, artists and for reading. It is compact, can be worn over
glasses and comes with 3 interchangeable lenses and an LED light.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all
circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product for purposes other
than those described above, the product may be damaged. In addition, improper use can result fires, or other hazards. Read
the instructions carefully and store them in a safe place. Make this product available to third parties only together with its
operating instructions.
This product complies with the statutory national and European requirements. All company names and product names are
trademarks of their respective owners. All rights reserved.
Delivery Content
•
Unit
• 3 x lenses
•
3 x LR 1130 Batteries
•
1 x plus head screwdriver
•
Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety
instructions and information on proper handling in this manual, we assume no liability for any resulting personal
injury or damage to property. Such cases will invalidate the warranty/guarantee.
a) General Information
•
The device is not a toy. Keep it out of the reach of children and pets.
•
Do not leave packaging material lying around carelessly. This may become dangerous playing material for
children.
•
Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture,
flammable gases, steam and solvents.
•
Do not place the product under any mechanical stress.
•
If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
-
has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
•
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
•
Consult an expert when in doubt about the operation, safety or connection of the appliance.
•
Maintenance, modifications and repairs must only be completed by a technician or an authorised repair
centre.
•
If you have questions which remain unanswered by these operating instructions, contact our technical support
service or other technical personnel.
•
Always cover the lens when not in use. Otherwise there is a risk of fire during direct sunlight since the lens
acts like a burning glass.
•
Do not touch the lens with your fingers (especially finger nails) or sharp/pointed objects.
•
Never use the lens to stare directly into bright light sources. There is a risk of eye damage!
•
Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
•
Never point the beam of light at mirrors or other reflective surfaces.
•
Never point the beam of light at persons or animals. This can lead to eye or skin injuries.
•
Always try to keep the beam of light out of eye level.
b) Batteries
•
Correct polarity must be observed while inserting the batteries.
•
The batteries should be removed from the device if it is not used for a long period of time to avoid damage
through leaking. Leaking or damaged batteries might cause acid burns when in contact with skin, therefore
use suitable protective gloves to handle corrupted batteries.
•
Batteries must be kept out of reach of children. Do not leave batteries lying around, as there is risk, that
children or pets swallow them.
•
All batteries should be replaced at the same time. Mixing old and new batteries in the device can lead to
battery leakage and device damage.
•
Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non rechargeable
batteries. There is a risk of explosion!
Operating Elements
1
2
3
4
5
6
1
LED ON/OFF switch
2 LED light
3 Lens bracket
4
Lenses
5 Nose bridge pad/arms
6
Battery compartment
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
*1712604_v2_0818_02_dh_m_4L
