Tool Shop 241-9931, Руководство пользователя

Страница: 13 / 23

13
TRIGGER SWITCH LOCK
– cont’d
To lock the trigger switch in the ON
position, pull back on the trigger switch (2)
to start the screwdriver and push the
trigger switch lock button (3) into the
screwdriver handle (Fig. 3). Release the
trigger switch while holding the trigger
switch lock button into the screwdriver
handle. The screwdriver will continue to
run. To release the trigger switch lock
button, pull trigger switch back and then
release the trigger.
NOTE: Operating the screwdriver with the
trigger switch ON for an extended period of
time may cause the screwdriver motor to
overheat. If the screwdriver gets hot, stop
driving screws and allow it to cool for at
least 15 minutes.
INSERTING A SCREWDRIVER BIT
This tool has a magnetic bit holder that
provides convenient bit changes. To install
a bit, simply insert the hex bit shank (1)
into the bit holder (2) that is located inside
the depth stop (3) (Fig. 4). Push the bit into
the bit holder until the magnet holds the bit
in place.
NOTES:
a) Use only 1" (25 mm) long bits that are
designed for use in driving drywall
screws.
b) Make sure the bit size is correct for
the drywall screws being driven. This
will usually be a #2 size.
ASSEMBLY AND OPERATING
Fig. 4
Fig. 3