7
WARNING:
Know your cordless
drill/driver. Do not plug in the charger or
install the battery in the tool until you have
read and understand this Instruction Manual.
Learn the tool’s applications and limitations,
as well as the specific potential hazards
related to this tool.
Following this rule will
reduce the risk of electric shock, fire, or serious
injury.
Always wear eye protection. Any
power tool can throw foreign
objects into your eyes and cause
permanent eye damage.
ALWAYS wear safety goggles (not glasses) that
comply with ANSI safety standard Z87.1.
Everyday glasses have only impact resistant
lenses. They ARE NOT safety glasses.
WARNING:
Glasses or goggles not in
compliance with ANSI Z87.1 could cause
serious injury when they break.
WARNING:
Always use a safety shield,
hearing protection and dust mask when
drilling concrete.
WARNING:
To avoid fire or toxic
reaction, never use gasoline, naphtha,
acetone, lacquer thinner or similar highly
volatile solvents to clean the tool.
WARNING:
Use only accessories that
are recommended for this cordless
drill/driver. Follow the instructions that
accompany the accessories. The use of
improper accessories may result in injury to
the operator or damage to the tool.
WARNING:
If any part is missing or
damaged, do not plug the tool into the power
source or install any accessory until the missing
or damaged part is replaced.
Do not drill material too small to be securely
held.
Always keep hands out of the path of the drill
bit. Avoid awkward hand positions where a
sudden slip could cause your hand to move into
the path of the drill bit.
Secure the workpiece. Use clamps or a vice to
hold the workpiece. It is safer than using your
hand and it frees both hands to operate the tool.
Make sure there are no nails or foreign objects
in the part of the workpiece to be drilled.
To avoid injury from accidental starting, always
remove the battery from the tool before installing
or removing a drill bit.
Do not i
nstall or use any drill bit that exceeds 7”
(17.5 cm) in length or extends more than 6” (15
cm) beyond the chuck jaws. They can bend or
break suddenly.
Before starting the operation, jog the drill/driver
switch to make sure the drill bit does not wobble
or vibrate.
Do not use fly cutters or multiple-part hole
cutters, because they can come apart or
become unbalanced during use.
Make sure the spindle has come to a complete
stop before touching the chuck or attempting to
change the drill bit.
Always make sure the chuck is tight and the drill
bit firmly tightened in the chuck before starting
drill/driver.
SPECIFIC SAFETY RULES
SAVE THESE INSTRUCTIONS FOR REFERENCE
SAVE THESE INSTRUCTIONS FOR REFERENCE
!
!
!
!
!
!
