-
cally.
-
cally.
MODES OF USE
Chop cut:
Miter cut:
Bevel cut:
Compound cut:
NOTE
:
side of the table to prevent interfering with the movement of the cutting head.
Always check before making the cut if there is any potential interference from the
clamp or any other part of the machine
.
OPERATING PROCEDURES
MAINTENANCE
NOTE:
ven though the angles are marked on the machine, it is always a good
idea to check them by making a trial cut. See Aligning Miter and Bevel, be
low.
-
soap and a damp (not wet) cloth.
lower blade
This is a good setting for 90° crosscuts.
miter lock knob(#11 in page 4).
Move the table rotation to the left or right up to 45° left & 55° right.
Quickly locate 0°, 15°, 22.5°, 30° and 45° left or right by the detent clicks at these angle
settings.
Tighten the miter lock knob at the desired angle.
