MAINTENANCE
CAUTION: Disconnect tool from the air supply before removing or installing the
contact tip.
!
r, reassemble in reverse order.
REGULAR MAINTENANCE
Clean and inspect the tool daily. Make sure the tool is disconnected from the air
supply.
Blow the tool clean with compressed air and inspect for wear or damage.
Use
necessary. DO NOT SOAK tool with cleaning solutions. Such solutions can
damage internal parts.
Inspect the trigger and the safety mechanism to assure the system is complete
and functional. Check for loose or missing parts, and any parts that may be
sticking.
Keep all the screws tight. Loose screws may cause personal injury
.
Place two or three drops of pneumatic oil (included) into the air inlet of the tool
daily.
ADJUSTING FASTENER DEPTH
The depth to which a fastener is driven is controlled by the depth adjustment (Fig.8).
The depth drive is adjusted to the maximum setting by the factory.
1. Fire a fastener into a scrap work piece to check depth.
2. Using wrench provided, adjust the safety element to achieve desired depth.
3. Fire another fastener in a scrap work piece and check the depth.
4. REPEAT AS NECESSARY UNTIL DESIRED DEPTH IS ACHIEVED. The amount
of air pressure required will vary depending on the size of the setting.
OPERATING PROCEDURES
Fig.8
!
CAUTION:
Never attempt to drive a fastener into material that is too hard, at too steep an
angle, or near the edge of the work piece. The fastener can ricochet causing
personal injury.
Carefully check for proper operation of the trigger and safety.
Do not use the tool unless both the trigger and the safety mechanism are
functional, or if the tool is leaking air or needs any other repair.
8
