Tool Shop 207-4825, Руководство оператора

Страница: 5 / 10

4
Note: This air tool may be shipped with a protective plug covering the air inlet.
Remove this plug before set up.
•
Incorporate a filter, regulator with pressure
gauge, oiler, in-line shutoffvalve, and quick
coupler for best service, as shown in the
diagram at left.An in-line shutoff ball valve is an
important safety device because it controls the
air supply even if the air hose is ruptured. The
shutoff valve should bea ball valve because it
can be closed quickly.
Note: If an automatic oiler system is not used,
add a few drops ofpneumatic tool oil to the
airline connection before operation.
Add a few more drops after each hour of
continual use.
• Attach an air hose to the compressor’s air inlet of the tool. Other components,
such as a coupler plug and quick coupler,
will make operation more efficient, but are not required.
PRESSURE AND OPERATE ACCIDENTALLY AFTER THE AIR SUPPLY IS
DISCONNECTED.
Note: Air flow, and therefore tool perfomance, can be hindered by undersized air
supply components.
1. The air hose must be long enough to reach the work area with enough extra
length to allow free movement while working.
2. Turn the tool’s throttle or switch to the off position; refer to Operation section
for description of controls.
3. Close the in-line safety valve between the compressor and the tool.
4. Turn on the air compressor according to the manufacturer’s directions and
allow it to build up pressure until it cycles off.
6. Inspect the air connections for leaks. Repair any leaks found.
7. If the tool will not be used at this time, turn off and detach the air supply, safely
discharge any residual air pressure, and release the throttle and/or turn the
switch to its off position to prevent accidental operation.
Note: Residual air pressure should not be present after the air supply is
disconnected. However, it is a good safety measure to attempt to discharge
the tool in a safe fashion after disconnecting to ensure that the tool is
unpowered.
Unpacking
Air Supply
TO PREVENT SERIOUS INJURYFROM ACCIDENTAL
OPERATION:
Do not install a female quick coupler on the tool. Such a
coupler contains an air valve that will allow the air tool to retain
WARNING:
TO PREVENT EXPLOSION Use only clean, dry, regulated,
compressed air to power this tool. Do not use oxygencarbon
dioxide, combustible gases, or any other bottled gas as a
power source for this tool.
WARNING:
OPERATING PROCEDURES
5. Adjust the air compressor’s output regulator so that the air output is enough to
properly power the tool, but the output will not exceed the tool’s maximum air
pressure at any time. Adjust the pressure gradually , while checking the air
output gauge to set the right pressure range.