Usage Instructions (Output Ionic Charge)
1. Clean treatment site prior to use
2. Hold the device in your hand in a relaxed manner with your
thumb or finger pressing the OUT button. To output ionic charge
press and hold OUT button. Red power level indicator will turn
green.
3. You can press the button for up to two minutes for continuous
output. After two minutes of continuous use the device will stop
outputting charge. Release the OUT button for five seconds and
then you can begin the next treatment.
4. Hold treatment nib gently against skin blemish and slowly move
back and forth until the whole blemish has been treated.
5. As the device touches your skin for the first time you may feel a
mild ionic charge on your skin..
6. During treatment you may notice the blemish becoming darker
in color. You may also notice a slight burning smell as the upper
surface of the skin ionizes.
7. You are strongly advised to first test the treatment process on
an inconspicuous area of skin.
What to Expect / After Treatment Care
The treated blemish may turn a darker color during or after the treatment. This will naturally exfoliate and the healing process will
begin. Clean the treated area with your regular cleansing regimen; do not over clean, artificially exfoliate or scratch the treated
area. Allow the area to naturally exfoliate Once this has happened, allow a healing period for the new skin.
Repeating Treatment
If the skin blemish was shallow, one treatment may be sufficient for removal. For deeper skin blemishes subsequent treatments
may be required. Only treat the same area after the skin has had sufficient time to fully heal.
Granulation Removal
Target the treatment at the root of
the granulation root cells. This will
encourage these skin cells to die
and stop 'feeding' the granulation. A
week after treatment you should
start to see the edges exfoliate.
After healing period, repeat
treatment so that granulation tissue
gradually reduces in size. If the
granulation is large, treat the
blemish in sections so that the
healing period is shortened.
Skin Tag Removal
Skin tags are tiny flaps of skin
connected by a thin “stalk”.
Generally skin tags can be removed
by the Spot Blaster Pro in one
session. 1) Make sure the standard
tip the unit came with is attached. 2)
With a pair of flat edge tweezers pull
the tag away from the skin 3) Treat
the entire base or stalk of the skin
tag with the device until the tag is
fully dislodged. 4) The area may
scab over. This is normal. It will heal
in about 5-10 days.
Mole Removal
If there is a chance that your mole
could be cancerous please consult a
doctor or a dermatologist before using
this device. Moles can vary
considerably in their form. The most
common difference is whether it sits
on the upper level of the skin, dermis,
or has ‘roots’ deeper in the epidermis
or even the subcutaneous tissue.
Even though you may feel the
blemish is 'large' you need to treat
moles in stages. Gradually treat the
surface of the mole and repeat the
treatment numerous times (allowing
for healing period in between) until
the desired results have been
obtained.
Tattoo Removal
For most tattoos, divide the surface
areas to be treated and address a
small section at a time. You can
treat different areas of the the tattoo
at the same time. Allow time for
each area to heal before treating a
different part of the tattoo.
Specific Use Cases
For Complete Instructions visit www.TommyTimmy.com/Instructions
Spot Blaster Pro Instructions
