How to Hang
Your Ceiling Fan
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 10).
!
WARNING
CEILING
FLOOR
AT
LEAST
7'
Figure 10
CEILING
COVER
PIN
DOWNROD
HANGER
BALL
SETSCREW
Figure 9
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly installed
could result in the fan falling.
!
WARNING
10.
Reinstall the hanger ball (Figure 9) on the
downrod as follows. Route the motor leads
through the downrod. Position the pin
through the two holes in the downrod and
align the ball so the pin is captured in the
groove in the top of the hanger ball. Pull the
hanger ball up tight against the pin and
securely tighten the setscrew in the hanger
ball. A loose setscrew could create fan wobble.
11.
The fan comes with blue, black and white
leads that are 80” long. Before installing
fan, measure up approximately 6 to 9-
inches above top of hanger ball/downrod
assembly. Cut off excess wire leads and
strip back insulation 1/2-inch from end of
leads.
COUPLING
COVER
DOWNROD
GROMMET
MOTOR
HOUSING
Figure 8
9.
Make sure the grommet is properly
installed in the coupling cover then slide the
coupling cover on the downrod until it rests
on the motor housing (Figure 8). Place the
ceiling cover over the downrod. Be sure
both the ceiling cover and the coupling
cover are oriented correctly (Figure 9).
CLEVIS
PIN
HAIRPIN
CLIP
DOWNROD
MOTOR
HOUSING
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
DOWNROD
HAIRPIN CLIP
MOTOR
COUPLING
SETSCREW (2)
CLEVIS PIN
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW (2)
CLEVIS PIN
Figure 7
8.
While pulling up on the downrod, securely
tighten the two setscrews in the motor
coupling (Figure 8).
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
8
BP7389 Prado TB310 2/1/09 2:29 PM Page 8
