14
Puissance
Features
Power
No-load speed
(1
st
speed)
No-load speed (2
nd
speed)
Ø agitator
Weight
Protection level
1800W
150 – 300min
-1
300 – 650 min
-1
140mm & 160mm
6.0 kg
II /
Safety
Safety instructions
o
To work as safely as possible with this tool, it is necessary to carefully read these operating and maintenance
instructions and to strictly comply with them.
o
You should also comply with the safety instructions inherent in the use of electrical tools.
o
Check the cord and the plug before each use. Make the defects repair by a technician.
o
This tool should not be used in wet premises, rain, fog, snow, or in an explosive atmosphere.
o
Check if the tool is off before plugging it to the mains. Should the case arise, check the position of the correspond-
ing commutator.
o
Use extreme caution with long hair and jewels. Work with appropriate, protective, waisted and buttoned clothes.
o
Fix the container with the mixed substances to the ground so as it cannot move.
o
Always set the cord at the rear of the tool. Do not excessively pull on the cord; do not put or pull on sharp edges.
o
Always work as steadily as possible, and keep your balance.
o
Use the additional handle.
o
Be ready to compensate for the torque when the tool starts working.
Use
Commissioning and application
A non compliant application may damage the tool. Please, comply with the below instructions:
o
Exclusively use tools with speci
fi ed diameter
o
Do not load the tool in such way the speed strongly reduces or the motor stops.
o
Check if the indications on the rating plate correspond to the real tension of the mains. The tools indicated for 230
V can also run on 220 V / 240 V.
Tighten the agitator
Screw as much as possible the tool with the M 14 x 2 tip in the chuck, and screw it
with the 22 wrench provided as accessory.
Starting and Stop
To start the tool, press on the switch
c
and keep on pressing it. The tool stops when
you release the switch
c
.
Permanent operation
Permanent operation Starting: press entirely on the switch
c
and at the same time on
the lock button
d
. The switch
c
is then blocked and permanent operation is activated.
Permanent operation Stop: press again on the switch
c
and then, release it. The
switch locking
c
is released and the permanent operation is stopped.
Disassembling the tool (agitator)
Locate the 22
fl at wrench
g
on the hexagonal nut situated at the end of the tool (agi-
tator), and then unscrew it from the chunk by turning on the left.
Electronic components of the motor / control of the motor electronic components
Starting current limitation
Slow-speed starting with electronic control guarantees smooth starting. It also has the ad-
vantage to avoid any projection of the liquids when the tool starts working. Thanks to the low
current when starting, a 16 A fuse is enough to protect the tool.
No-load speed reduction
The electronic components reduce the speed of the tool when it works with no load. It allows
reducing the sound level, as well as the motor and gears wear.
c
d
f
