Tomcat VR, Руководство по эксплуатации

Страница: 14 / 29

- 14 - TR-OP-EN
SWEEPING:
1. Turn on machine Key Switch (A) .
2. Check the Battery Gauge to ensure proper charge
before starting to sweep (B) .
3. Lower the Main Broom to the fl oor by dropping the
Main Broom Lift Lever forward (C) .
4. Lower the Side Brooms head to the fl oor by dropping
the Side Broom Lift Lever forward (D) .
5. Turn on the Main Broom Motor by pressing the Main
Broom Motor Switch (E) .
6. Turn on the Side Broom Motors by pressing the Side
Broom Motors Switch (F) .
7. Set the speed of the Side Brooms by dialing the Side
Broom Speed Control (G) (Clockwise = Fastest /
CounterClockwise = Slowest) .
8. Begin sweeping by depressing the Foot Pedal (H)
slowly and then to the speed required.
9. Once the machine begins to move, check the Broom
Amp Gauge (I) . This Gauge allows the Operator to
see if there are issues in regards to the Broom type
for certain applications, if something was tangled in
the Broom, or other small issues that could cause the
circuit to blow.
10. To operate the machine in reverse, simply switch the
Reverse switch (J) back towards the rear of the ma-
chine. The reverse speed is set to approximately 50%
of the forward speed.
11. To stop the machine, release the Foot Pedal and the
machine will stop automatically (H) .
WET SWEEPING:
1. Turn on machine Key Switch (A) .
2. Check the Battery Gauge to ensure proper charge
before starting to sweep (B) .
3. Lower the Main Broom to the fl oor by dropping the
Main Broom Lift Lever forward (C) .
4. Lower the Side Brooms head to the fl oor by dropping
the Side Broom Lift Lever forward (D) .
5. Open the WET Sweep By-Pass door by rotating it
clockwise (K) . This door being open reduces the Dust
Control. Always remember to close door when sweep-
ing again once on dry ground.
6. Turn on the Main Broom Motor by pressing the Main
Broom Motor Switch (E) .
7. Turn on the Side Broom Motors by pressing the Side
Broom Motors Switch (F) .
8. Set the speed of the Side Brooms by dialing the Side
Broom Speed Control (G) (Clockwise = Fastest /
CounterClockwise = Slowest) .
9. Begin sweeping by depressing the Foot Pedal (H)
slowly and then to the speed required.
10. Once the machine begins to move, check the Broom
Amp Gauge (I) . This Gauge allows the Operator to
see if there are issues in regards to the Broom type
for certain applications, if something was tangled in
the Broom, or other small issues that could cause the
circuit to blow.
11. To operate the machine in reverse, simply switch the
Reverse switch (J) back towards the rear of the ma-
chine. The reverse speed is set to approximately 50%
of the forward speed.
12. To stop the machine, release the Foot Pedal and the
machine will stop automatically (H) .
C
K
J
H
F
D
G
E
I
B
A