OPTIONAL BATTERY CHARGING
ON BOARD CHARGER
CAUTION:
THE FOLLOWING INSTRUCTIONS ARE INTENDED
FOR THE 36V CHARGER SUPPLIED WITH THE MACHINE.
DO NOT USE ANY OTHER CHARGER WITH THIS MACHINE.
1. TRANSPORT MACHINE TO A WELL VENTILATED AREA FOR
CHARGING.
2. TURN THE MACHINE OFF.
3. HINGE OPEN THE TANK TO EXPOSE THE BATTERIES.
(SEE FIGURE 50.) CAUTION:
(ALWAYS WEAR EYE
PROTECTION WHEN BATTERIES ARE EXPOSED)
4. CHECK THE WATER LEVEL IN EACH BATTERY. DO NOT
CHARGE THE MACHINE UNLESS THE WATER IS SLIGHTLY
HIGHER THAN THE PLATES. IF NEEDED, ADD ENOUGH
DISTILLED
WATER TO 1/2" ABOVE THE PLATES. DO NOT
OVER FILL. BATTERIES CAN OVERFLOW DURING
CHARGING. REPLACE CAPS BEFORE CHARGING.
5. PLUG THE EXSTENTION CORD INTO A
GROUNDED 110 VOLT STANDARD WALL OUTLET.
(SEE PICTURE TO THE LEFT)
6. CONNECT THE EXTENTION CORD INTO THE ON BORD
BATTERY CHARGER LOCATED ON THE FRONT OF THE
FRAME STEERING COLUMN.
(SEE PICTURE TO THE LEFT)
7. THE CHARGER WILL AUTOMATICALLY BEGIN CHARGING,
AND AUTOMATICALLY SHUT OFF WHEN FULLY CHARGED
(CHECK GAUGE)
8. AFTER THE CHARGER HAS TURNED OFF, UNPLUG THE
EXSTENTION CORD FROM THE MACHINE AND DISCONNECT
FROM THE WALL OUTLET.
(SEE PICTURE TO THE LEFT)
9. RECHECK THE CELL LEVEL AFTER CHARGING. IF NEEDED,
ADD DISTILED WATER UP TO THE CORRECT LEVEL. BE
CERTAIN TO REPLACE THE CAPS SECURELY AND TO WIPE
OFF THE TOP OF THE BATTERIES.
CHARGER SPECIFICATIONS
OUTPUT VOLTAGE OF 36 VOLTS. (STANDARD)
OUTPUT CURRENT OF 25 AMPS MAX. (STANDARD)
INPUT VOLTAGE OF 110 VOLTS/60 HZ. (STANDARD)
AUTOMATIC SHUT OFF CIRCUIT.
MADE FOR DEEP CYCLE BATTERIES.
DANGER:
ALWAYS CHARGE BATTERIES IN A WELL
VENTILATED AREA. BATTERIES EMIT HYDROGEN GAS.
EXPLOSION OR FIRE CAN RESULT. KEEP SPARKS AND
FLAME AWAY. SHEILD EYES WHEN SERVICING BATTERIES
AND AVOID CONTACT WITH BATTERY ACID.
LEAVE
ACCESS PANEL OPEN WHEN CHARGING!
PAGE 25
Содержание 250 series
