IS0802-00
11-08-18
Wiring the AC Models
1.
Ensure that power is off.
2.
Install conduit to conduit opening and tighten set screw.
3.
Pull field wiring through conduit into enclosure/base.
4.
Remove the threaded dome assembly by twisting it counterclockwise.
5.
Remove the LED light engine assembly by removing 2 screws attaching the metal disk to the case.
6.
Connect the black lead to 120-240VAC 50-60Hz phase (hot) side of the power source and the white
lead to the common (neutral) side of the AC power source. Connect the green wire to ground.
7.
Select the mode of operation, either flashing or steady burn mode, via either internal dip switch or
external connections of the blue and yellow wires. See Table 1 for proper settings and connections.
Note: 1. Dip switches will override any external wire connections.
Note: 2. If the blue and yellow wires are not used cut off or cap with a wire nut.
TABLE 1
Internal Dip Switch Settings for setting modes of operation
Switch 1
Switch 2
Mode
On
Off
Single flash 2 380mS On, 380ms Off
Off
On
Double flash @200mS On, @00mS On, 900mS Off
On
On
Off
Off
Off
Steady Burn PWM @ 66.4%
External Wire Connections for setting modes of operation
Yellow
Blue
Mode
Line
Neutral
Single flash 2 380mS On, 380ms Off
Neutral
Line
Double flash @200mS On, @00mS On, 900mS Off
Line
Line
Off
Neutral
Neutral
Steady Burn PWM @ 66.4%
Notes: The yellow and blue wires can also be connected to PLC controller for mode
activation. For a PLC the input voltage can be either be AC or DC, but must be greater
than 100 volts RMS and no more than 240 volts RMS
8.
Replace the LED light engine assembly and attach 2 screws.
9.
Secure the dome to the base of the beacon.
10.
Connect power to the beacon and test it for proper operation
Wiring 24 VAC/VDC Models (4375L-24)
1.
Ensure that power is off.
2.
Install conduit to conduit opening and tighten set screw.
3.
Pull field wiring (including external mode operation wiring, if applicable) through conduit into
enclosure/base.
4.
Remove the threaded dome assembly by twisting it counterclockwise.
5.
Remove the LED light engine assembly by removing 2 screws attaching the metal disk to the case.
6.
Connect the black lead to 12-30VAC 50-60Hz phase (hot) or 12-30VDC positive DC side of the
AC/DC power source and the white lead to the common (neutral) side or negative DC side of the
AC/DC power source. Connect the green wire to ground.
7.
Select the mode of operation, either flashing or steady burn mode, via either internal dip switch or
external connections of the blue and yellow wires. See Table 2 for proper switch settings and wire
connections.