15. Cut free both sides of the elevators
using a sharp hobby knife. Carfully bend
the elevators up and down to „loosen“ the
hingeline. Make sure not to overextend the
ailerons
DO NOT cut off the elevators at the
hingeline.
14. Install the thin and long fiberglass rod.
ATTENTION: Do not cut this rod. It is
meant to be continuous and in one piece
going from wingtip to wingtip.
13. Extend the total length of the servo
leads to 60mm or 2.4 inches. Install the
servos
including
the
linkages.
!ATTENTION! Test the servos sub trim
before proceeding and apply glue only to
the servo flaps.
Repeat steps 12 and 13 in order to finish
the other wing half.
Tomahawk Design 89284 Pfaffenhofen GERMANY
Keine Haftung für Druckfehler Technische Änderungen vorbehalten Stand 09-2010
Made in Germany
Seite 11
