Tomahawk JXPC50H, Руководство по эксплуатации и инструкция

Страница: 13 / 26

4.5 Spark Plug
(Fig. 5)
Clean or replace spark plug as needed to ensure proper operation. Refer to the engine
owner's manual.
The muffler becomes very hot during operation and remains hot for a while after stop-
ping the engine. Do not touch the muffler while it is hot.
Note: Refer to the Technical Data for the recommended spark plug type and the
electrode gap setting (page 6).
To change fluid:
4.4.1 Remove beltguard, belt, and hose from water tank.
4.4.2 Remove four screws (b) securing console assembly to baseplate and lift console
assembly from baseplate.
b
73 Nm
(54 ft.lbs)
30 Nm
(22 ft.lbs)
c
a
Fig. 4
4.4.3 Remove end cover (c) from bear-
ing exciter assembly. Outer bearing race
will remain with cover.
4.4.4 Tip baseplate up and drain fluid
from exciter assembly. Dispose of used
fluid in an appropriate manner. Contact
local recycling center.
4.4.5 Add 150 ml (5 ounces) of automat-
ic transmission fluid to exciter housing
and fasten end cover to exciter. Do not
overfill exciter or bearings may over-
heat.
4.4.6 Set up console assembly to base-
plate and install belt, beltguard, and
hose to water tank.
1 3