13
ENGLISH
Then clip the linkage to the servo and rudder
horn and adjust the linkage by the clevis to
achieve a neutral rudder at 90° servo arm.
07
Sand the rudder control horn well and glue into
the rudder by using epoxy resin.
05
Connect the ESC to the motor and install it
under the wooden tray in the front.
08
Open the linkage outlet with a small round
file.
06
The receiver has its place in the rear of the fuselage and should be fixed by foam and/or velcro
at the fuselage.
09
The battery will be fixed by velcro loops on the
front battery tray.
10
This position may vary to achieve the center
of gravity.
11
