EN - 16
PRIOR TO FIRST USE
Before using the appliance for the first time, proceed as follows: carefully unpack the induction hob and remove all packaging
material. Keep the packaging (plastic bags and cardboard) out of reach of children. After unpacking the appliance, carefully check it
for external damage that may have occurred during transport.
Place the induction hob on a firm, flat and heat resistant surface. Clean the induction hob with a slightly damp cloth. Check that
the voltage corresponds with the voltage stated on the information plate before you insert the plug in the socket.
OPERATING THE HOB
Only use pans that are suitable for an induction hob and have the correct size with a cross-section from 15 to 20 cm.
The induction hob has two cooking zones and each cooking zone has its own control buttons. Both cooking zones are operated
in the same way.
The induction hob works by means of electronic sensors that are operated by touching the corresponding touch control. Each
time the touch control is touched or the position knob is turned, you can hear a sound signal. Make sure the operating section
is always clean and dry.
PLACE A PAN ON THE CERAMIC PLATE
• Check that the ventilation openings are not blocked and do not place cookware in the direct vicinity of the induction hob.
• Place the pan with food or liquid in the centre of a cooking zone.
INSERT THE PLUG IN THE SOCKET
• When the plug is inserted in the socket, a beep will sound. [--] flashes on the display.
SWITCHING ON THE INDUCTION HOB
• Press the on/off button once. The display shows [on] and the cooking zone is ready for heating.
• If the cooking zone is not operated within 1 minute after switching it on [on], the induction hob automatically returns
to standby [--].
ADJUSTING A POSITION
• Turn the position knob to set the induction hob to the required position.
The induction hob has 10 positions, of which [1] is the lowest position and boost [P] is the highest position.
Position
1
2
3
4
5
6
7
8
9
Boost
Shown on display
1
2
3
4
5
6
7
8
9
P
• If there is no pan on the cooking zone after switching it on, the induction hob will not get hot. One minute later, the induction
hob switches off automatically.
SWITCHING OFF THE INDUCTION HOB
• Press the on/off button once to switch off the cooking zone manually or set the position knob to 0.
Caution: the glass plate will be hot [HH].
RESIDUAL HEAT INDICATOR
The residual heat indicator shows that the glass plate is still too hot to touch in the area of the cooking zone.
If the area of the cooking zone is still too hot, [HH] appears on the display. When the temperature gets lower, but is still hot,
the indication [HH] will change into [hh]. The temperature of the glass plate is low, when [--] is flashing on the display.
BOOST MODE
The Boost mode provides extra power for a short period of time.
• Switch on the induction hob and turn the position knob to the highest position, Boost. The Boost mode is active when a [P]
appears on the display. After 5 minutes, the Boost mode automatically switches back to position 9.
When a different position is selected, the Boost mode is cancelled.
Caution:
the Boost mode cannot be used on both cooking zones at the same time. When a cooking zone has the Boost mode
activated and the other cooking zone is also switched to Boost mode, the setting of the first cooking zone is automatically
adjusted to a lower position.