3) Manual Tuning Mode
After the ANT (antenna) selection is finished, you may enter the manual tuning mode
by pressing FUNCTION button one more time.
<Fig6> shows a status where you can manually tune C
1
by SELECT dial.
Then pressing the
③
SELECT dial, prompt (
＞
) sign shifts to C
2
(C2
＞
XXX), and you
can tune C
2
by dial.
C
1
and C
2
must be reciprocally changed to tune for minimal SWR (or Pr) on SWR/PWR
meter.
If the minimal SWR (or Pr/ reflected power) is obtained, you may start to transmit with
full power.
(Note: Auto band set will not track at Manual Tuning mode, if you change the band of
radio.)
4) Flow of Operation
①
To set the BAND: If your tuner is connected to HL-1.5KFX and/or HL-2.5KFX with a
supplied band control cable, skip this step
①
and go to
②
(To set the ANT
selection).
If the amplifier is other than two models above of Tokyo Hy-Power Labs., you need
to set the BAND manually as follows;
Press Function button once. On LCD, “
＞
”mark is displayed and requests you to
further put in the data.
<Fig7>
>
1.8 Mz MANU FUNC
C1=XXX C2=XXX ANT1
Turn Select dial to the desired band of operation.
Press ENTry dial and tuner will be back to Operation Mode. If above setting is
finished, motors will run to drive variable capacitors to the respective pre-set
positions.
“WAIT” is displayed just for a short period, until the pre-setting finishes. <Fig8>
<Fig8>
Xxx Mz BAND WAIT
C1=XXX C2=XXX ANTx
11
