Tokyo Electronic CS3910H, Руководство по эксплуатации

Страница: 4 / 22

Q
Handling Precautions
Q
Handling Precautions
3
CAUTION
;
Avoid
Do NOT connect/disconnect connectors with power ON.
Before connecting/disconnecting connectors, make sure to check if the system is
powered OFF. Doing so with power ON may cause a damage or an electric shock
accident.
;
Avoid
Do NOT give a strong shock/impact against the camera-head.
Avoid giving a strong shock against the camera head. The camera-head might be
damaged.
;
Avoid
Do NOT pull/swing the cable forcefully
Do not pull strongly the camera cable/camera-head nor swing it. The stress from
pulling or swinging may cause damage in the coating of the cable, or breaks in
the inside wires.
DANGER
;
Avoid
Do NOT place any potentially-hazardous stuff on this device.
Do NOT place any object on the device which may, if it gets into the inside of the
body, damage the inner parts of the device (such as a flower pot, glass, cosmetics,
a container filled with liquids or chemicals, as well as small metal parts, etc.). If
tumbled, the liquids inside the bottle, etc. may get into the chassis, causing a fire
or an electric shock accident.
;
Avoid
Do NOT short-circuit signal outputs.
Avoid short-circuit of signal outputs. Otherwise it may cause damage to the
camera. For inspection of inner parts/circuits, adjustment, maintenance, contact
us or the dealer/distributor from which you purchased the camera.
;
Avoid
Do NOT use the camera in a high-humidity environment.
Do NOT place the camera near a humidifier, or in other high-humidity
environment.
To do so may cause a fire or an electric shock accident.
;
Avoid
Do NOT expose the camera to direct sunlight, nor intensive heat.
Do not place the camera where it is exposed to direct sunlight, or in a higher
temperature than guaranteed (Over 40 degrees Celsius). To do so may cause the
inner temperature of the camera to go up, resulting in burning-down of inner
arts, circuits or a fire accident.
;
Avoid
Do NOT expose the camera to greasy fumes.
Do NOT place the camera at the location where it is exposed to greasy fumes or
steams, or heavy dusts. To do so may cause the inner temperature of the camera to
go up, resulting in burning-down of inner parts/circuits or a fire accident.