Hose connection
WARNING
Install the metallic cap of the air hose onto the body of the air tool firmly. The metallic cap will come off and
cause the hose to run amuck due to vibration if the metallic cap is used in a loose condition. This will be very
dangerous.
Check for damage of the air hose and in the connection part of the air tool body.
Confirm that there is no dust or dirt.
Do not point the air hose at anyone.
Never use compressed air to clean cloth.
Operation
CAUTION
Keep your feet away from the chisel. There would be a risk for injury if the chisel drops onto the operator' s foot
when the chisel is broken.
Never operate an air tool at an air pressure over the limit of the air tool.
Confirm that the retainer of the chisel is locked firmly before starting the air tool.
Never start an air tool without a chisel.
Always hold an air tool with both hands. Confirm that the handle is clean without any grease or oil.
Do not place the air tool on a person's foot.
Always keep well balanced during operation.
Never get on a tool. For example, do not put one foot on the handle of the air tool.
This may become a reason to get hurt especially when the air tool is broken.
Investigate the material of the work. For example, when using the tool for electric and telephone cable, water
and drain pipe, etc, inspect for hidden cable or pipe underground before operating an air tool.
In case the chisel hits something during operation, stop the air tool immediately.
Restart the tool after the danger is cleared.
Service and maintenance
Turn the valve cock of the compressor completely to the stop position, hold down the throttle valve and release
the pressure in the air hose completely before disconnecting an air tool.
Read and understand the instruction manual correctly. Contact with the selling agent or distributor of the
manufacturer for further service information if necessary.
Whet it is necessary to use solvent to clean parts, be sure it is within the safety standards first, then use the
solvent at a place with good ventilation.
Never be careless
Always concentrate on the work.
Always use common sense.
Eye vision and reaction deteriorate significantly in fatigue conditions after taking medicine, or drinking alcohol.
Never use an air tool when you are under the influence of these conditions.
Always direct exhaust away from yourself and others in the aria.
Always disconnect tool from the air supply when not in operation.
If quick-disconnect couplings are used, separate the coupling from the tool with a leader hose.
Always make sure cutting chisel is securely latched in the tool before depressing throttle trigger.
Always hold cutting tool down firmly on the work before depressing throttle trigger.
3
Air & Allied Sales (Pacific) Pty Ltd
