15
fig. 26
fig. 27
THE ASSEMBLY OF THE HORIZONTAL PROFILES (HOR 1, 2, 3)
a) Photos 20 and 21, install the upper profiles HOR1 (straight cut) on top of the central pillars, locating the extremes on
top of the upper plate, fig 28. Situate and screw the screws without pressing them yet. The 550x366 pools do not
have an upper HOR1 profile, so you need to start with the HOR 2 profile (section b).
b) Locate all of the upper profiles HOR2 on top of the vertical columns, on top of the T2 plate, photos 22 and 23. Match
the holes on them and screw the screw without pressing them yet.
c) Adjust the upper profiles until you locate them together, but without putting one on top of the other. Press all of the
screws, photo 23.
fig. 28
foto 22
foto 23
Important:
If any of the vertical columns (VER) is not straight with respect to the ripple wall, adjust the vertical column giving light
hammer blows to a piece of wood on the base plate (T1). If the top of the vertical column is not aligned it must also be adjusted
.
ASSEMBLY OF THE TOP HUB CAPS (EMB y EMBR)
Align a trim (EMB) in the curve on the ends of two top profiles. Hook the trim underneath the internal edges of the top profiles,
photo 23 and pull towards you, photo 24, hooking the trim on the outer part, photo 25. Repeat with the other trims.
Align a trim (EMBR) in the straight part, hook the bezel below the inner edges of the top profiles and pull towards you, hooking
the trim on the exterior part.
LAST DETAILS
-
You must place the Warning Sticker in a visible place, fig. 29, 30.
foto 20
foto 21
foto 23
foto 24
foto 25
