6.
Cordless Kettle Owner’s Manual
6. Plug the Power Base into 120V AC electrical outlet.
7. Press the ON/OFF Lever down, into the ON position, the
Indicator Light will come on.
8. When the water comes to a boil the Kettle will automatically
shut off and the Indicator Light will turn off.
NOTE:
The Kettle can be turned off at any time during the
heating process by using the ON/OFF Lever.
9. Remove the Kettle from the Power Base before pouring.
NOTE:
Always wait until the Kettle is off before removing it
from the Power Base.
10. To reheat water, place Kettle back onto Power Base and press
ON/OFF Lever down, into the ON position. Be careful not to
spill any water onto the Power Base.
11. Unplug the Power Base when not in use. Allow it to cool before
reuse.
Cleaning Your Kettle
CAUTION: Do not immerse Kettle or Power Base in any liquid or
place in a dishwasher to be cleaned.
1. Raise the ON/OFF Lever into the OFF position and unplug
unit. Allow unit to cool before cleaning.
2. Open the Lid by pressing the Lid Release Buttons together and
lifting up (Refer back to Figure 3).
3. Remove the Scale Filter from inside the Kettle by pressing down
on tab on the front of the filter inside of spout. (See Figure 4a).
Pull up and out from
the Lid Opening.
(See Figure 4b).
Rinse under running
water and use a soft
brush if necessary
(do not use a metal
brush). Replace Scale
Filter.
Boiling Instructions
(Cont.)
FIGURE 4a
FIGURE 4b
TMR_TEK17W_IB_18-10-07 10/18/07 4:32 PM Page 6
