GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug.
(2 blades and 1 pin) If the plug does not fit fully into the electrical outlet
contact a qualified electrician. Do not modify the plug in any way or
use an adaptor.
BEFORE FIRST USE
1. Read all instructions carefully and keep them for future reference.
2. Remove all packaging.
3. Install the Filter. (See Care and Cleaning section)
4. Water boiled for the first time should be discarded.
INSTRUCTIONS FOR USE
1. Install the Filter, if not already in place (see the Care & Cleaning section).
Never use this kettle without the filter. Removal of the Filter may prevent
the Kettle from shutting off.
2. Open the Lid by sliding the latch towards the handle and lifting upward.
Fill the Kettle through the Lid opening, with a minimum of .5 litres of water.
DO NOT attempt to fill the Kettle while it is plugged into the wall outlet.
DO NOT use for other than boiling water. Other liquids will contaminate
the interior of the Kettle.
DO NOT fill past the MAX level indicated in the water level window.
Overfilling may cause water to spill out when boiling.
3. Close Lid. Note: The Lid should not be opened when the Kettle is hot.
4. Place Kettle on a level, dry, heat resistant surface.
5. Plug cord into a 120V AC wall outlet. Note: NEVER PLUG KETTLE INTO
AN ELECTRICAL OUTLET WHEN KETTLE IS EMPTY.
6. Depress the On/Off Switch (‘I’/’O’) and the red indicator light will light up
to indicate that the Kettle is in the boil cycle. Once the water has boiled,
the On/Off Switch will move to the 'Off' (‘O’) position and the light will
go out. IMPORTANT: The kettle shuts off automatically only after the
boiling cycle is complete. If the kettle is unplugged before the boiling
cycle is complete then it will begin to heat as soon as it is plugged in
3
TJK-100 Book v001 7/27/04 5:18 PM Page 9
