Toa VP-2241, Инструкция по эксплуатации

Страница: 30 / 328

Chapter 2: PRODUCT DESCRIPTIONS
2. NOmENclATurE AND fuNcTIONS
2-14
2.8. Surveillance Frame VX-2000SF
RUN FAULT POWER
SETTINGS
ATA FLASH CARD
ACCESS
DS-SF
LINK
1
2
IN
OUT
SLOT No.
AUDIO
LINK
DC POWER IN
STANDBY
PA LINK
DATA
LINK
10 9 8 7 6 5 4 2 1 3
SURVEILLANCE FRAME VX-2000SF
[Front panel detached]
[Rear]
[Front]
4 5 6 7 8
9
11
13
15
16
18
17
2 3 1
2 3 1
19
10
12 14
• The VX-2000SF Surveillance Frame is the main matrix section of the VX-2000 system that assigns audio
signals to individual zones from 4 audio buses. It can be extended to up to 8 units*.
• A total of 10 units of output modules and control modules can be installed per VX-2000SF. The following
4 types of modules can be used: the VX-200SP Pilot Tone Detection module, the VX-200SZ Impedance
Detection module, the VX-200SI control Input module, and the VX-200SO control Output module.
• The output module features a failure detection function, and can detect failures that occur between the VX-
2000 unit and the speaker lines.
• One standby amplifier can be connected per VX-2000SF. Should the power amplifier fail, output is automatically
switched to the standby amplifier.
• The output volume to the power amplifier can be set using the PC system software.
* Available when the label on each packing box of the VX-2000 system components (VX-2000, VX-2000Sf,
rm-200X, and rm-200Xf) indicates "EN80," and the Setting Software Version is 3.0 or later.