4. INSTALLATION
4.1. Set the input power
Step 1.
Loosen the cable gland.
Step 2.
Loosen the base screws and pull out the base
assembly.
Step 3.
Initially set to max wattage, the red lead wire can be
set to the desired wattage setting.
Cover the base after completing the setup. When covering, pull
the cable out first to avoid the cable getting stuck inside the
speaker. After the base is screw-locked, finally fix the cable gland.
[Notes]
・
Do not change another lead wires except for the red lead wire.
・
These speakers are designed to be used for high impedance
application. Never connect the speaker to low impedance line.
4.2. Speaker installation
Step 1.
Install the attached Multi Bracket seat of part (A) onto
rear side of the speaker with the attached hexagonal
screws.
Step 2.
Install the attached Multi Bracket seat of part (B) to the
wall with the self-tapping screws.
Step 3.
Set the speaker unit by inserting Multi Bracket part (B)
into part (A).
Step 4.
Fix the hex socket head cap screw of part (A).
Step 5.
Fix another hex socket head cap screw to combine the
Multi Bracket part (B) with part (A).
Step 6.
Connect the cable.
[Notes]
・
Speaker must be connected to the correct line terminals of
amplifier.
・
Minimum distances of 30mm around the apparatus for sufficient
ventilation.
・
Do not use this speaker with its front upward to prevent
malfunction.
・
Waterproof the cable joint by wrapping insulating tape around it
when the joint may be exposed to rain or water.
3
