Toa SB-30W, Инструкция по эксплуатации

Страница: 3 / 8

Specifications(Assembled Two HLS30S2-8 Low-Frequency Loudspeakers)
Enclosure: Vented (bass-reflex) type
Tuning Frequency : 75 Hz
Applicable Speaker Unit : HLS30S2-8X2
Nominal Impedance : 4 ohms
Power Handling
1
: 600 W continuous pink noise
Sensitivity
2
:101 dB(1W/1m)
Frequency Range: 65 Hz~4,000 Hz
Highest Recommended Crossover Frequency: 1,000 Hz
Input Termlnal: 2P screw terminal(M5)
Material: Particle board
Finish : Paint
Dimensions: 880(H)X440(W)X300(D)mm
Weight
Including speaker unit: 41kg
Only enclosure:19kg
Accessories
Rubber spacer:4
Instruction manual: 1
Warranty card: 1
Rear board mounting screw: 14
Note
1. AES Standard (60 to 600 Hz)
2. Sensitivity is based on a band-limited (100 to 800 Hz) pink noise signal.
3. Specifications are subject to change without notice.
Installation Examples
The SB-30W is a fixed enclosure for reproducing low frequencies. A high-efficient low
frequency speaker system consists of the SB-30W and two HLS30S2-8 woofers, and a high-
linearity, wide-range two-way speaker system is configured in addition to TOA's LE-series
constant directivity horns and HFD-series compression driver.
When driving the speaker system with multi-amplifier operation, the time alignment and
speaker system phase can be set to their optimum performance conditions by using our
integrated sound processor "SAORI" as a divider. When driving the standard speaker
system(GS-302W) with passive operation, use the optional HNW-800 dividing network and two
HLS30S2-16 woofers.
Mounting the Low-Frequency Loudspeakers
1. Remove the rear board.
2. Screw each speaker unit to the baffle board from the inside of the baffle at 8 places. (The
screws are attached to the speaker unit.)
3. Connect the cables to the speaker unit. Connect the red cable to the red terminal and
connect the black cable to the black terminal.
4. Replace the rear board by screwing at 16 places.
Note: Be sure to install each speaker unit from the inside of the enclosure baffle board.
Suspending the Enclosure
Before mounting the speaker unit, mount the HY-38S suspension kit to the enclosure. For
details, refer to the HY-38S's instruction manual.
When suspending this speaker, make sure to suspend it after investigating structure of
installation locations, and confirming that the suspending wires or belts are heavy-duty to this
speaker.
Mounting the Horn
When the standard speaker system(GS-302W) is configured, the constant directivity horn LE-
M94 is mounted on the SB-30W with the horn mounting bracket HY-M94. For details, refer to
the HY-M94's instruction manual.
Mounting the Dividing Network
When using the HNW-800 dividing network, detach the terminal panel at the back of enclosure
and mount the HNW-800 dividing network. For details, refer to the HNW-800's instruction
manual.
Installing the Enclosure
If necessary, attach the provided rubber spacer to the four locations at the bottom of the
enclosure.
- 3 -