9
Step 4.
Connect the speaker cables to the input terminal.
Connect both the input line (cable from the amplifier) and bridge line (cable to the next speaker) to the
input terminal.
Rear case secured to the ceiling
Reinforcement bracket
Input terminal
Speaker cables
Bind the speaker cables to the reinforcement bracket
using its idle holes with the cable ties (2 places).
Intermediate connector
Connect when installing the front case. (See Step 7.)
Input terminal
Allows branch wiring.
Push button
Press this button to connect or disconnect the speaker cables.
From the amplifier
To the next speaker
COM (-)
HOT (+)
9 mm
1. Strip the cable sheath about 9 mm from the cable end.
Use a strip gauge printed on the nameplate.
2. Insert the core wire while holding down the push button, then release the button.
Pull on the cable lead to ensure it is securely inserted.
Connections
Disconnection
Pull out the cable lead while holding down the push button.
Applicable cable
Solid copper wire: ø 0.8 - 1.6 mm (AWG 20 - 14 or equivalent)
7-core twisted copper wire: 0.75 - 1.25 mm
2
(AWG 18 - 16 or equivalent)
Do not house
cables.
Note
Bind the speaker cables, keeping away from this shaded section.
If the speaker cables are housed in the shaded section, they touch the
matching transformer and the front case cannot be installed properly.
