8
10. Control output terminal
Allows control of external equipment in
synchronization with the unit operation.
11. Functional ground terminals
If excessive noise is produced when the
speaker is connected to external equipment,
connect this terminal to the external
equipment’s functional ground terminal,
potentially minimizing the noise level.
Note
This terminal is not for protective ground.
12. DIP switch
• Line/Mic switch (Switch 1)
Set this switch to MIC when connecting a
microphone, and to LINE when connecting
a general sound source device other than
a microphone.
Default setting: LINE
• PAD switch (Switch 2)
Enables or disables the MIC input pad.
When the input level is high, set the PAD
to –20 dB.
Default setting: 0 dB
• Phantom switch (Switch 3)
Set whether or not to supply phantom
power to the microphone connected to
MIC IN. Phantom power is a 12 V DC.
Default setting: OFF
• Mute switch (Switch 4)
When using Mute terminal (9), set this
switch to on.
Note
Do not set this switch when nothing is
connected to the Mute terminal (9). It
will be recognized as control signal mute
enable (24 V DC cut) and will mute the
system.
13. Monitor output terminal
Enables monitoring the multicast audio
stream output with the monitor output.
14. Reset key
The unit begins to restart when this key is
clicked.
Hold down this key until the Status indicator
(1) lights yellow to initialize the unit’s
settings.
15. Rubber feet attachment position
7. HANDLING PRECAUTIONS
• Please apply the latest firmware version to this product. The latest version is available at the TOA
DATA Library (https://www.toa-products.com/international/).
• As this product is IP-based, a slight time lag between actual and broadcast may happen.
• Broadcast audio may sometimes break up due to packet loss or network failure.
• Periodic inspection and manual rebooting are needed to extend the product life.
•
This product may reboot automatically to keep the stable operation.
